v0.1 · BETA
> 3DWEST.ORG [↑] BLENDER 101MODULE 1L05 Basic Modeling
[ SEARCH ]
3DWEST.ORG / BLENDER 101 / MODULE 1 / L05
BLENDER 4.2 LTS V0.1 90-150 min
LESSON 5

Basic Modeling

Extrusions, loop cuts, and your first building

  • Use Loop Cut to add edge loops and control mesh density
  • Use Extrude to push faces and create volume from a flat plane
  • Apply the Subdivision Surface modifier with intent
  • Use Inset Faces to create recessed panels
  • Model a simple low-poly house
STEP 01 / 02

Lesson setup

By now you have pushed and pulled a cube around in Edit Mode. This is where that practice starts to pay off. You are going to model a simple house using Loop Cut, Extrude, and a little bit of cleanup discipline.
LESSON 5 HOMEWORK

A render of a finished low-poly house from a clean three-quarter angle. Include four walls, a roof, one window inset, and a door opening. Plain gray material is fine.

Post to #l5-homework →